Fitting The Battery Into Spark Ignition Generator (Fs); Checking The Ignition Operation - Valor Inspire L Installer And Owner Manual

10.2 Fitting the battery into the spark ignition
generator.
At the front of the electronic spark generator there is a
removable circular battery cover. Unscrew the cover in
an anticlockwise direction. Remove any protective film
from the battery if applicable and place into the
generator. The negative (-) terminal should go in first.
The battery is marked with (+). Screw back on the cap.

10.3 Checking the ignition operation.

Push the slider handle to the LEFT as far as
-
possible till the ignition is visible, several sparks
should be generated and heard between the
electrode and pilot tip.
If there are no sparks check the following:
-
Ensure that the electrode lead is connected
-
to the terminal at the base of the electrode.
If the above is correct, check for damage to
-
the electrode lead and that the battery has
been correctly fitted.
©
GDC Group Ltd. SEPT 2018
INSTALLER GUIDE
Page 21