Fitting The Wall Liners; Fitting The Rear Wall Liner; Fitting The Glass Liners Spacer Support; Fitting The Side Wall Liners - Valor Inspire L Installer And Owner Manual

INSTALLER GUIDE
13.

FITTING THE WALL LINERS

There are a range of wall liners available some may have a patterned/colouring or in the
case of the glass a mirrored side depending on the liner set purchased. Ensure the
decorated or glass mirrored side is fitted facing outwards.
NOTE: All liners must be fitted into the convector box before the engine is refitted.
PLEASE NOTE: Care must be taken to avoid damage to the liners when fitting.

13.1 Fitting the rear wall liner.

Locate the rear liner against the rear
wall of the convector box.
Please note that when fitting this
liner into the convector box it should
be angled first on the flat to fit inside
the inner convector box then gently
raised to locate into the rear wall
section.

13.2 Fitting the Glass liners spacer support.

NOTE: This must be carried out before fitting any of the Glass
wall liners.
Inside the accessory box you will find two metal spacer brackets
and 4 screws. Locate the glass liner spacer to the LHS and RHS
of the convection box using the 4 screws supplied.

13.3 Fitting the side wall liners.

Offer the side wall liners into the convection box. The angled top
of the ceramic side walls should be located first. With the top in
place gently slide the side wall until it is flat against the side of
the convection box.
Ensure they are pushed in fully both sides so as not to interfer
when refitting the burner assembly.
© Page 25
GDC Group Ltd. SEPT 2018