Burner And Supply Pipe Installation; Burner Installation; Supply Pipe Installation; Burner Checks - Fs Model - Valor Inspire L Installer And Owner Manual

INSTALLER GUIDE

14. BURNER AND SUPPLY PIPE INSTALLATION

14.1 Burner installation.

1. Ensure the transformer location is confirmed and the DC jack connector is fitted
through the grommet into the convector box as as described in (Section 11) and
connected to the burner unit.
2. Refit the burner unit to the convection box with following the steps and with the
screws removed previously in (Section 9).

14.2 Supply pipe installation.

1. A nut and olive is provided for an 8mm-pipe inlet
connection directly to the gas control. The isolating 'T'
connector can be rotated to allow a connection from the
rear. The 'T' connector includes a valve for isolating the gas
supply.The supply pipe must be rigid material. Flexible pipe
must not be used. Connect the supply line to the appliance.
2. If closed open the isolating valve at the inlet 'T'
,
connector.
3. Turn on the gas supply and pressure check the
installation pipework for gas soundness. In the United
Kingdom (GB) check in accordance with the current edition of BS 6891. In the
Republic of Ireland check in accordance with the current edition of IS 813 "Domestic
Gas Installations".
Some burner operations can be checked at this stage along with the function of the
LEDS. Checking now will mean that less disassembly will be required if any problems
are found.
NOTE: A full check should still be made, however, after final installation. Only
leave the burner alight long enough to confirm its operation.

14.3 Burner checks - FS model

14.3.1 Lighting the fire.
-
If closed open the isolating 'T' connector valve.
,
Push the slider handle to the LEFT as far as possible till the ignition position is
-
reached, several sparks will occur between the electrode and pilot tip. Hold in this
position till the pilot flame has heated the thermocouple sufficiently to hold.
Approx. 5 - 15 seconds.
©
Page 26
GDC Group Ltd. SEPT 2018