3H - 24 Hour Day Timer/Thermostat Mode And Snooze Mode; 3I - Setting "Snooze Mode" In Manual Operation; 3J - Setting "Snooze Mode" In Thermostatic Mode - Valor Inspire L Installer And Owner Manual

3h - 24-hours Day Timer/Thermostat mode and snooze mode.
Snooze mode can be selected to work with in conjunction with either manual or
thermostatic modes.
You can switch between modes at any time with the handset unlocked by pressing
and releasing mode button to toggle between modes.
Note: If at any time the power button is pressed during operation, this will stop the
fire and exit any automatic mode and return the handset to manual (MAN) operation
mode.

3i - Setting "snooze mode" in manual operation

Snooze mode is a time period you can set which will turn off the fire after a certain
Benchmark Commissioning and Servicing
time period has elapsed.
Section
The snooze time period can be set before or during manual operation of the fire. Hold
the handset to unlock as described previously and press the mode button as many
times as necessary until the word MAN and the Zzz symbols are flashing at the top of
the display. Press and release the set button and this will put the control into Manual
snooze mode.
The default time period for the snooze time period is 1:00 hour. Pressing the set
button again will show you the snooze time period remaining. This can be adjusted by
pressing the "+" or "- "buttons. The timer period that can be set is from 1 minute to
4:00 hours.
After adjusting the time, press set again to enter the time setting required (or if left for
a few seconds this time is now stored and used).
Once this countdown timer has reached zero the fire will turn off (as if you had
pressed off manually, it does not recycle).

3j - Setting "snooze mode" in Thermostatic mode

The same thing as above can be done before or during a thermostatic mode
operation.
The handset has within it a thermostat sensor and this can be set so the fire will heat
the room to match he temperature set in the handset.
There are 3 temperature types that can be set: -
-Day mode temperature that has a sun symbol on the display – the default
temperature is 24 C
- Night temperature that has a half moon symbol on the display- the default
temperature setting is 18 C
-frost protection that has a snowflake symbol on the display – the default
temperature setting is 5 C
Hold handset and press and release the mode button several times as necessary
www.centralheating.co.uk
until the display has a thermometer symbol flashing at the top of the display. Press
the set button to enter this mode.
Press the set button again to see the temperature setting that is set and the mode
(the default is 24 C ) and on the left of the display is a sun
symbol showing it's the day temperature.
© Page 49
GDC Group Ltd. SEPT 2018