Fitting Batteries Into Remote Control Handset (Rc); Fitting Batteries Into The Valve (Rc); Setting The Handset And Reciever Relationship (Rc) - Valor Inspire L Installer And Owner Manual

INSTALLER GUIDE
Remote Control (RC) Model
10.4 Fitting batteries into the remote control handset.
The remote control handset is battery powered. There are two
1.5 Volt Alkaline 'AA' size batteries supplied. Remove the rear
battery compartment cover from the remote control handset.
Fit the batteries in to the handset. Replace the cover.
10.5 Fitting batteries into the Valve.
The gas valve is battery powered.
There are three 1.5 Volt Alkaline 'AA' size batteries supplied.
Locate the batteries in the valve, remove the front battery
compartment cover from the valve and fit the batteries.
It is important that the positive (+ve) and
negative (-ve) symbols on the battery match
those of the illustration inside the battery holder.
Replace the cover.
10.6 Setting the handset and receiver
relationship.
The reciever and handset are linked before leaving the
factory but if either component are replaced the receiver
will have to be set to learn the handset / remote code. Do
this as below:
- Picking up and holding the handset will unlock the
keypad and the green light will illuminate a solid green.
NOTE: Ensure the small isolation slide switch on the top
left of the gas fire control is slid to the right, (I) position to
turn the power on to the valve.
- Place the handset near the fire, i.e.within a metre. No
need to hold the handset at this time.
- Simultaneously press and hold the - and + buttons on the gas valve control (not
the handset) until the red light on top left of fire control begins to flash rapidly,(it will
take about 5 seconds to start flashing), then immediately release the - and +
buttons and quickly pressing just the power button on the gas fire control valve. Note:
Pressing of the power button must be done within 1 second of the red light coming
on. If not done quickly enough, then the above must be repeated until done correctly.
- When done correctly you will hear an audible sound from the handset and the
display will show the symbol " ⎤- - " and the green light on the handset will be
flashing. You now have 60 seconds to accept the pairing. To do this pick up and hold
the handset and hold it like a handshake to activate the unlocking of the keypad and
press and hold the "SET" button for a few seconds.
- You will hear a few beeps from the handset and the display will change and enter
the setup menu .
- Whilst maintaining your grip on the handset, you can now set the display functions
©
Page 22
GDC Group Ltd. SEPT 2018