3K - Setting The "24 Hour Day Timer/Thermostat" Mode - Valor Inspire L Installer And Owner Manual

If a different set temperature is required, while the display is showing this set
temperature, press the + and – buttons to alter the setting. When finished either press
set or leave and after a few seconds the new setting will be accepted and the display
will return to the time of day screen.
On the anniversary of the net minute of the clock, the set temperature will be
compared to the actual temperature displayed on the handset (i.e. the room ambient
temperature around the handset). If the room temperature is higher than the set
temperature the fire will not light until the room has cooled to below the set
temperature. The fire would then automatically turn itself on when the room is cooler
than the set temperature and down and off if necessary when it is hotter than the set
temperature.
Note- when the set temperature is reached while the fire is in operation, the fire
reduces the burner power level each minute until the burner is off.
The pilot (if fitted) will remain on for a further 30 minutes and if the set temperature is
still too high; the pilot will then also extinguish. When the set temperature is higher
than the actual temperature, the fire will automatically light and go to the full burner
rate to reheat the room back to the set temperature.
Note: If at any time the power button is operated during Thermostat mode, the control
will cancel any thermostat operation and return the control to manual mode.
For ease of setting there are two other modes that can be selected as stated above.
Night mode (moon symbol) and frost protection setting (a snow flake). These can be
selected (and adjusted if necessary) by pressing set then mode while in thermostat
mode. Pressing mode button toggles through from day to frost modes. The purpose
of these settings is to help your fire to automatically protect you home against
becoming too cold if there is a sudden change in the weather. The control must be left
in the appropriate mode for this to function.
Note: As stated in an earlier section, snooze function can also be operated in
conjunction with thermostat mode. The thermostat symbol and the Zzz symbol will be
on together when in this mode.
3k - Setting the "24-hours Day Timer/Thermostat" mode
This mode enables the various day, night and frost thermostat modes to be set on a
program timer. The control will work as a thermostat switching between the day, night
and frost temperature settings in line with the program set.The setup of the timer will
be shown by a demonstration.
To set up the timed thermostat to be at 24 C from 06:00 to 09:00 then drop to 18 C
from 09:00 to 15:30 and then 24 C again from 15:30 until 23:30 and then to protect
from frost a 5 C setting between 23:30 to 06:30 the next day from Monday to Friday
this is what you would do: -
Hold handset to unlock – press set and hold until a beep and release. Press MODE
button until the timer symbol is flashing on the top of the display – press SET to enter
the time mode – Mo is flashing so it is already set for Monday- press SET and
release now press the + and – buttons to make the time of day read 06:00 (note the
steps are in 15 minutes steps) – press SET and release- press + and – to make the
©
Page 50
GDC Group Ltd. SEPT 2018