Led Fuel Effect Operation; Metal And Painted Parts; Removing And Cleaning The Window Assembly - Valor Inspire L Installer And Owner Manual

4. LED fuel effect operation.

Ensure the transformer is plugged into a suitable mains
supply and the wall socket is switched ON.
Switch ON the LED fuel effect simply by flicking the rocker
switch as shown resulting in the red marking showing.
The 8 LEDs will come ON and begin gently pulsing.
NOTE: If no LEDS function check the Transformer wall socket switch is in the On
position and the On/Off switch on the appliance is in the correct position.
NOTE: The LED circuit is seperate to that of the gas and its ignition circuit, so they
can both be operated seperately or together to give the desired effect.
CLEANING YOUR APPLIANCE
To maintain the high performance and quality finish of your fire please follow these
guidelines:
- Before attempting to clean the appliance, please remember to turn off the appliance
and wait for the appliance to cool completely. The fire will retain heat for some time
before cleaning can begin.

Metal and painted parts.

- Clean the metal and painted parts with a slightly damp, lint free non-abrasive cloth
and then dry.
- Do not use abrasive cleaners, as these will scratch the appliances surface.

Removing and cleaning the window assembly.

Removal of the window assembly is only necessary if you wish to clean the rear of
the window or access the ceramic components. The window assembly can be
cleaned with a mild detergent and water. Glass cleaner can also be used. Any stains
on the glass can be removed with a non-abrasive cleaner such as a ceramic hob
cleaner. Never use abrasive cleaners. Clean the window carefully in accordance with
the instructions supplied with the cleaner.
1. The window door panel is secured at the bottom with one hand tightened M5
knurled screw.
2. With this knurled screw removed, gently pull the base of the window panel forward.
©
Page 52
GDC Group Ltd. SEPT 2018