OWNER GUIDE
1b - Fireslide - adjusting flame height.
When the burner is operating step the slider handle to the RHS, increments will be
felt as the slider moves giving you the following outputs;
Position 1 - After ignition Center burner is on LOW
Position 2 - Moving slider handle one increment to RHS, Center burner is on HIGH.
Position 3 - Moving slider handle one more increment to the RHS, both Outer
burners on HIGH ignite (along with the Center burner remaining on HIGH)
Position 4 - Moving the slider as far as possible to the RHS is OFF
Note: There is no pilot only setting on the Slider (FS) model.
1c - Fireslide - turning OFF.
To turn the fire OFF push the slider as far as possible to the RHS.
2. Gas valve control (401RC model)
2a - Lighting the gas fire & operation The gas valve control is situated on your fire.
The drawing below shows the main features of the control.
©
Page 45
GDC Group Ltd. SEPT 2018