Link Layer Discovery Protocol (Lldp) - TRENDnet TI-PG541i User Manual

TRENDnet User's Guide
Web Configuration
Advanced Settings > EEE
Parameter Description
Click a port to enable IEEE 802.3az Energy Efficient Ethernet on
EEE Port State
that port.
Click this to enable IEEE 802.3az Energy Efficient Ethernet across
Select All
all ports.
Click this to disable IEEE 802.3az Energy Efficient Ethernet across
Deselect All
all ports.
Apply Click Apply to configure the settings.
Refresh Click this to reset the fields to the last setting.
© Copyright 2016 TRENDnet. All Rights Reserved.

Link Layer Discovery Protocol (LLDP)

The Link Layer Discovery Protocol (LLDP) specified in this standard allows stations
attached to an IEEE 802® LAN to advertise, to other stations attached to the same IEEE
802 LAN, the major capabilities provided by the system incorporating that station, the
management address or addresses of the entity or entities that provide management of
those capabilities, and the identification of the station's point of attachment to the IEEE
802 LAN required by those management entity or entities.
The information distributed via this protocol is stored by its recipients in a standard
Management Information Base (MIB), making it possible for the information to be
accessed by a Network Management System (NMS) using a management protocol such
as the Simple Network Management Protocol (SNMP).
Default Settings
The LLDP on the Switch is disabled.
Tx Interval : 30 seconds.
Tx Hold : 4 times.
Time To Live : 120 seconds.
Port Status Port Status
---- ------- ------ -------
1 Enable 2 Enable
3 Enable 4 Enable
5 Enable 6 Enable
CLI Configuration
Node Command
enable show lldp
enable show lldp neighbor
TI-PG541i
Description
This command displays the LLDP configurations.
This command displays all of the ports' neighbor
information.
44