TRENDnet TI-PG541i User Manual page 62

TRENDnet User's Guide
Web Configuration
Advanced Settings > PoE > PD Alive Check
Parameter Description
State Enables/Disables the PD Alive Check.
Port Selects a port or a range of ports which you want to configure.
State Enables/Disables the PD Alive Check for the specific port(s).
IP Address
Specifies the Host IP address which connects to the port.
The interval to send the packet probes to check if the host is still
Interval
alive.
The retry times when no response from the host for the keep-a-
Retry Time
live probe packet.
The action to the Power Device when the system detects that the
Action
Power Device cannot respond the keep-a-live probe packet. The
options have Reboot / Alarm / All /None.
When PD has been rebooted, the PoE port restored power after
Power Off Time
the Power Off Time time.
© Copyright 2016 TRENDnet. All Rights Reserved.
The Switch waits the Start Up Time to do PoE Auto Checking
Start Up Time
when the PD is rebooting.
Apply
Click Apply to take effect the settings.
Refresh
Click Refresh to begin configuring this screen afresh.
Power Delay
The Power Delay allows the user to setting the delay time of power providing after device
rebooted.
CLI Configuration
Node Command
enable show poe power-delay
interface poe power-delay
(enable|disable)
interface poe power-delay time VALUE
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range poe power-delay
(enable|disable)
TI-PG541i
Description
This command displays the PoE power
delay configurations.
This command enables / disables of the
Power Delay function for the specific
port.
This command configures the delay
time of the Power Delay for the specific
port.
This command enters the interface
configure node.
This command enables / disables of the
Power Delay function for the range of
ports.
52