TRENDnet TI-PG541i User Manual page 20

TRENDnet User's Guide
1. The SNTP server always replies the UTC current time.
2. When the Switch receives the SNTP reply time, the Switch will adjust the time
with the time zone configuration and then configure the time to the Switch.
3. If the time server's IP address is not configured, the Switch will not send any
SNTP request packets.
4. If no SNTP reply packets, the Switch will retry every 10 seconds forever.
5. If the Switch has received SNTP reply, the Switch will re-get the time from NTP
server every 24 hours.
6. If the time zone and time NTP server have been changed, the Switch will
repeat the query process.
7. No default SNTP server.
Default Settings
Current Time:
-----------------------------------------------
Time: 0:3:51 (UTC)
Date: 1970-1-1
Time Server Configuration:
-----------------------------------------------
Time Zone : +00:00
IP Address: 0.0.0.0
DayLight Saving Time Configuration:
-----------------------------------------------
State : disabled
Start Date: None.
End Date : None.
© Copyright 2016 TRENDnet. All Rights Reserved.
CLI Configuration
Node Command
enable show time
configure time HOUR:MINUTE:SECOND
configure time date YEAR/MONTH/DAY
configure time daylight-saving-time
configure time daylight-saving-time
start-date (first | second |
third | fourth | last) (Sunday
| Monday | Tuesday |
Wednesday | Thursday |
Friday | Saturday) MONTH
OCLOCK
configure time daylight-saving-time
end-date (first | second |
third | fourth | last) (Sunday
| Monday | Tuesday |
Wednesday | Thursday |
Friday | Saturday) MONTH
OCLOCK
TI-PG541i
Description
This command displays current time
and time configurations.
Sets the current time on the Switch.
hour: 0-23
min: 0-59
sec: 0-59
Note: If you configure Daylight Saving
Time
after you configure the time, the
Switch will apply Daylight Saving Time.
Sets the current date on the Switch.
year: 1970-
month: 1-12
day: 1-31
This command enables the daylight
saving time.
This command sets the start date for
the Daylight Saving Time.
For Example: first Sunday 4 0 (AM:0 1st
Sunday in April)
This command sets the end date for
the Daylight Saving Time.
For Example: Last Sunday 10 18 (PM: 6
Last Sunday in October)
10