TRENDnet TI-PG541i User Manual page 36

TRENDnet User's Guide
CLI Configuration
Node Command
enable show queue cos-map
enable show qos mode
configure queue cos-map
PRIORITY QUEUE_ID
configure no queue cos-map
configure qos mode high-first
configure qos mode wfq-queue
configure qos mode wrr-queue
weights VALUE VALUE
VALUE VALUE VALUE
VALUE VALUE VALUE
interface default-priority
interface no default-priority
enable show diffserv
configure diffserv
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
This command displays the current 802.1p
priority mapping to the service queue.
This command displays the current QoS
scheduling mode of IEEE 802.1p.
This command configures the 802.1p priority
mapping to the service queue.
This command configures the 802.1p priority
mapping to the service queue to default.
This command configures the QoS scheduling
mode to high_first, each hardware queue will
transmit all of the packets in its buffer before
permitting the next lower priority to transmit
its packets.
This command configures the QoS scheduling
mode to Weighted Fair Queuing.
This command configures the QoS scheduling
mode to Weighted Round Robin.
This command allows the user to specify a
default priority handling of untagged packets
received by the Switch. The priority value
entered with this command will be used to
determine which of the hardware priority
queues the packet is forwarded to. Default: 0.
This command configures the default priority
for the specific port to default (0).
This command displays DiffServ
configurations.
This command disables / enables the DiffServ
(disable|enable)
configure diffserv dscp VALUE
priority VALUE
Web Configuration
Port Priority
Advanced Settings > Bandwidth Control > QoS
Parameter Description
Use this field to set a priority for all ports.
All Ports 802.1p
The value indicates packet priority and is added to the priority tag
priority field of incoming packets. The values range from 0 (lowest
priority) to 7 (highest priority).
Port This field displays the number of a port.
Select a priority for packets received by the port. Only packets
802.1p Priority without 802.1p priority tagged will be applied the priority you set
here.
TI-PG541i
function.
This command sets the DSCP-to-IEEE 802.1q
mappings.
26