TRENDnet TI-PG541i User Manual page 52

TRENDnet User's Guide
This field displays the ports that have been assigned as untag
Untag Ports
ports.
Port Settings
Advanced Settings > VLAN > VLAN > Port Settings
Parameter Description
Select a port number to configure from the drop-down box.
Port
Select All to configure all ports at the same time.
PVID Select a PVID (Port VLAN ID number) from the drop-down box.
Specify the type of frames allowed on a port. Choices are All,
VLAN Untagged Only or VLAN Tagged Only.
- Select All from the drop-down list box to accept all untagged or
tagged frames on this port. This is the default setting.
Acceptable
Frame
- Select VLAN Tagged Only to accept only tagged frames on this
port. All untagged frames will be dropped.
- Select VLAN Untagged Only to accept only untagged frames on
this port. All tagged frames will be dropped.
Apply Click Apply to save your changes back to the Switch.
Refresh Click Refresh to begin configuring this screen afresh.
© Copyright 2016 TRENDnet. All Rights Reserved.
Port Status
Port This field displays the port number.
PVID This field displays the Port VLAN ID number.
Acceptable This field displays the type of frames allowed on the port. This will
Frame either display All or VLAN Tagged Only or VLAN Untagged Only.
MAC-based VLAN
The MAC base VLAN allows users to create VLAN with MAC address. The MAC address
can be the leading three or more bytes of the MAC address.
For example, 00:01:02 or 00:03:04:05 or 00:01:02:03:04:05.
When the Switch receives packets, it will compare MAC-based VLAN configures. If the SA
is matched the MAC-based VLAN configures, the Switch replace the VLAN with user
configured and them forward them.
For example:
Configurations: 00:01:02, VLAN=23, Priority=2.
The packets with SA=00:01:02:xx:xx:xx will be forwarded to VLAN 22 member ports.
Notices: The 802.1Q port base VLAN should be created first.
CLI Configuration
Node Command
enable show mac-vlan
configure mac-vlan STRINGS
vlan VLANID priority
<0-7>
TI-PG541i
Description
This command displays the all of the mac-vlan
configurations.
This command creates a mac-vlan entry with the
leading three or more bytes of mac address and
the VLAN and the priority.
42