TRENDnet TI-PG541i User Manual page 19

TRENDnet User's Guide
Jumbo Frame
Jumbo frames are Ethernet frames with a payload greater than 1500 bytes. Jumbo frames
can enhance data transmission efficiency in a network. The bigger the frame size, the
better the performance.
Notice:
The jumbo frame settings will apply to all ports.
If the size of a packet exceeds the jumbo frame size, the packet will be dropped.
The available values are 10240, 9216, 1522, 1536, 1552.
Default Settings
The default jumbo frame is 10240 bytes.
CLI Configuration
Node Command
enable show jumboframe
configure jumboframe
(10240|9216|1522|1536|1552)
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
This command displays the
current jumbo frame settings.
This command configures the
maximum number of bytes of
frame size.
Web Configuration
Basic Settings > General Settings > Jumbo Frame
Parameter Description
This field configures the maximum number of bytes of frame size
Frame Size
for specified port(s).
Apply Click this button to take effect the settings.
Refresh Click this button to reset the fields to the last setting.
SNTP
The Network Time Protocol (NTP) is a protocol for synchronizing the clocks of computer
systems over packet-switched, variable-latency data networks. A less complex
implementation of NTP, using the same protocol but without requiring the storage of
state over extended periods of time is known as the Simple Network Time Protocol
(SNTP). NTP provides Coordinated Universal Time (UTC). No information about time
zones or daylight saving time is transmitted; this information is outside its scope and must
be obtained separately.
UDP Port: 123.
Daylight saving is a period from late spring to early fall when many countries set their
clocks ahead of normal local time by one hour to give more daytime light in the evening.
Note:
TI-PG541i
9