TRENDnet TI-PG541i User Manual page 69

TRENDnet User's Guide
configure snmp trap-receiver
IPADDR VERSION
COMMUNITY
Example:
TI-PG541I#configure terminal
TI-PG541I(config)#snmp enable
TI-PG541I(config)#snmp community public rw trusted-host 192.168.200.106/24
TI-PG541I(config)#snmp trap-receiver 192.168.200.106 v2c public
TI-PG541I(config)#snmp system-contact IT engineer
TI-PG541I(config)#snmp system-location Branch-Office
Web Configuration
SNMP Setting
Management > SNMP > SNMP > SNMP Settings
Parameter Description
Select Enable to activate SNMP on the Switch.
SNMP State
Select Disable to not use SNMP on the Switch.
© Copyright 2016 TRENDnet. All Rights Reserved.
This command configures the trap receiver's
configurations, including the IP address,
version (v1 or v2c) and community.
Type a
System Name
(The System Name is same as the host name)
System Location Type a System Location for the Switch.
System Contact Type a System Contact for the Switch.
Apply Click Apply to configure the settings.
Refresh Click this button to reset the fields to the last setting.
Community Name
Management > SNMP > SNMP > Community Name
Parameter Description
Enter a Community string, this will act as a password for requests
from the management station.
An SNMP community string is a text string that acts as a password.
Community
It is used to authenticate messages that are sent between the
String
management station (the SNMP manager) and the device (the
SNMP agent). The community string is included in every packet
that is transmitted between the SNMP manager and the SNMP
agent.
TI-PG541i
System Name for the Switch.
59