System Log - TRENDnet TI-PG541i User Manual

TRENDnet User's Guide
Firmware
Management > Maintenance > Firmware
Type the path and file name of the firmware file you wish to upload to the Switch in the
File path text box or click Browse to locate it. Click Upgrade to load the new firmware.
Reboot
Management > Maintenance > Reboot
Reboot allows you to restart the Switch without physically turning the power off.
Follow the steps below to reboot the Switch.

In the Reboot screen, click the Reboot button. The following screen displays.
© Copyright 2016 TRENDnet. All Rights Reserved.

Click OK again and then wait for the Switch to restart. This takes up to two minutes.
This does not affect the Switch's configuration.

System Log

The syslog function records some of system information for debugging purpose. Each log
message recorded with one of these levels, Alert / Critical / Error / Warning / Notice /
Information. The syslog function can be enabled or disabled. The default setting is
disabled. The log message is recorded in the Switch file system. If the syslog server's IP
address has been configured, the Switch will send a copy to the syslog server.
The log message file is limited in 4KB size. If the file is full, the oldest one will be
replaced.
CLI Configuration
Node Command
enable show syslog
enable show syslog level
LEVEL
TI-PG541i
Description
The command displays the entire log message
recorded in the Switch.
The command displays the log message with
the LEVEL recorded in the Switch.
65