TRENDnet TI-PG541i User Manual page 30

TRENDnet User's Guide
General Settings
CLI Configuration
Node Command
enable show interface IFNAME
configure interface IFNAME
interface show
interface loopback (none | mac)
interface flowcontrol (off | on)
interface speed (auto|10-full||10-half|
100-full|100-half|1000-full)
interface shutdown
interface no shutdown
interface description STRINGs
interface no description
interface cable test
interface clean cable-test result
interface show cable-test result
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
This command displays the current
port configurations.
This command enters the interface
configure node.
This command displays the current
port configurations.
This command tests the loopback
mode of operation for the specific
port.
This command disables / enables
the flow control for the port.
This command configures the
speed and duplex for the port.
This command disables the specific
port.
This command enables the specific
port.
This command configures a
description for the specific port.
This command configures the
default port description.
This command diagnostics the
Ethernet cable and shows the
broken distance.
This command cleans the test
result of the Ethernet cable test.
This command displays the test
result of the Ethernet cable test.
configure interface range
gigabitethernet1/0/ PORTLISTS
if-range description STRINGs
if-range no description
if-range shutdown
if-range no shutdown
if-range speed (auto|10-full||10-half|
100-full|100-half|1000-full)
Example:
TI-PG541I#configure terminal
TI-PG541I(config)#interface gi1/0/1
TI-PG541I(config-if)#speed auto
Web Configuration
Basic Settings > Port Settings > General Settings
TI-PG541i
This command enters the interface
configure node.
This command configures a
description for the specific ports.
This command configures the
default port description for the
specific ports.
This command disables the specific
ports.
This command enables the specific
ports.
This command configures the
speed and duplex for the port.
20