TRENDnet TI-PG541i User Manual page 46

TRENDnet User's Guide
The RIP version 2 group address, used to send routing information
224.0.0.9 using the RIP protocol to all RIP v2-aware routers on a network
segment
EIGRP group address. Used to send EIGRP routing information to all
224.0.0.10
EIGRP routers on a network segment
224.0.0.13 PIM Version 2 (Protocol Independent Multicast)
224.0.0.18 Virtual Router Redundancy Protocol
224.0.0.19 - 21 IS-IS over IP
224.0.0.22 IGMP Version 3 (Internet Group Management Protocol)
224.0.0.102 Hot Standby Router Protocol Version 2
224.0.0.251 Multicast DNS address
224.0.0.252 Link-local Multicast Name Resolution address
224.0.1.1 Network Time Protocol address
224.0.1.39 Cisco Auto-RP-Announce address
224.0.1.40 Cisco Auto-RP-Discovery address
224.0.1.41 H.323 Gatekeeper discovery address
CLI Configuration
Node Command
enable show mac-address-table
multicast
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
This command displays the current
static/dynamic multicast address
entries.
configure mac-address-table multicast
MACADDR vlan VLANID ports
PORTLIST
configure no mac-address-table
multicast MACADDR
Web Configuration
Advanced Settings > IGMP Snooping > Multicast Address
Parameter Description
VLAN ID Configures the VLAN that you want to configure.
MAC Configures the multicast MAC which will not be aged out.
Address Valid format is hh:hh:hh:hh:hh:hh.
Port Configures the member port for the multicast address.
Apply Click Apply to save your changes back to the Switch.
Refresh Click Refresh to begin configuring this screen afresh.
TI-PG541i
This command configures a static
multicast entry.
This command removes a static
multicast entry from the address table.
36