TRENDnet TI-PG541i User Manual page 14

TRENDnet User's Guide
CLI Command Modes
Node Command
enable show hostname
configure reboot
eth0 ip address A.B.C.D/M
interface show
vlan show
The Node type:

enable
Its command prompt is "TI-PG541I#".
It means these commands can be executed in this command prompt.

configure
Its command prompt is "TI-PG541I(config)#".
It means these commands can be executed in this command prompt.
In Enable code, executing command "configure terminal" enter the configure
node.
TI-PG541I# configure terminal

eth0
Its command prompt is "TI-PG541I(config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface eth0" enter the eth0
interface node.
TI-PG541I(config)#interface eth0
TI-PG541I(config-if)#
© Copyright 2016 TRENDnet. All Rights Reserved.
Description
This command displays the system's network
name.
This command reboots the system.
This command configures a static IP and subnet
mask for the system.
This command displays the current port
configurations.
This command displays the current VLAN
configurations.

interface
Its command prompt is "TI-PG541I(config-if)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "interface gigaethernet1/0/5" enter
the interface port 5 node.
Or
In Configure code, executing command "interface fastethernet1/0/5" enter
the interface port 5 node.
Note: depend on your port speed, gigaethernet1/0/5 for gigabit Ethernet
ports and fastethernet1/0/5 for fast Ethernet ports.
TI-PG541I(config)#interface gigaethernet1/0/5
TI-PG541I(config-if)#

vlan
Its command prompt is "TI-PG541I(config-vlan)#".
It means these commands can be executed in this command prompt.
In Configure code, executing command "vlan 2" enter the vlan 2 node.
Note: where the "2" is the vlan ID.
TI-PG541I(config)#vlan 2
TI-PG541I(config-vlan)#
TI-PG541i
4