TRENDnet TI-PG541i User Manual page 67

TRENDnet User's Guide
interface traffic-monitor recovery
(disable|enable)
interface traffic-monitor recovery
time VALUE
configure interface range
gigabitethernet1/0/
PORTLISTS
if-range traffic-monitor
(disable|enable)
if-range traffic-monitor rate
RATE_LIMIT type
(bcast|mcast|bcast+mcast)
if-range traffic-monitor recovery
(disable|enable)
if-range traffic-monitor recovery
time VALUE
© Copyright 2016 TRENDnet. All Rights Reserved.
This command enables / disables the
recovery function for the traffic monitor on
the port.
This command configures the recovery
time for the traffic monitor on the port.
This command enters the interface
configure node.
This command enables / disables the traffic
monitor on the port.
This command configures the packet rate
and packet type for the traffic monitor on
the port.
bcast – Broadcast packet.
mcast – Multicast packet.
This command enables / disables the
recovery function for the traffic monitor on
the port.
This command configures the recovery
time for the traffic monitor on the port.
Web Configuration
Monitor > Traffic Monitor
Parameter Description
State Globally enables / disables the traffic monitor function.
Port The port range which you want to configure.
State Enables / disables the traffic monitor function on these ports.
Action Unblock these ports.
Packet Type Specify the packet type which you want to monitor.
Packet Rate Specify the packet rate which you want to monitor.
Enables / disables the recovery function for the traffic monitor
Recover State
function on these ports.
Configures the recovery time for the traffic monitor function on
Recovery Time
these ports.(Range: 1 – 60 minutes)
TI-PG541i
57