Table of Contents
Advertisement
Figure 45.
5.
Click OK.
The DataViewer commands window opens.
6.
Send serial commands directly through the selected COM port to the attached AV
device.
7.
To end the direct access session, close DataViewer.
NOTE: You can force the direct access session closed by logging on as administrator
and entering Esc
Serial Bridging
Serial bridging mode allows you to pass serial data between two COM ports through an
Ethernet port, creating a virtual serial connection over a LAN.
To use serial bridging, two IPL T S devices (one local and one remote) must be enabled to
communicate with each other, providing PC or controller access to a remote AV device.
Hardware connection
To set up the hardware for serial bridging:
DataViewer Communication Setup Dialog Box
X!
}
X!
*0CD
, where
is the selected COM port.
IPL T S Series • Communication and Control
50
Advertisement
Table of Contents
