Extron electronics IPL T S Series User Manual page 40

Command ASCII (Telnet)
(Host to Unit)
Firmware Version, Part Number and Information Requests
NOTES:
•
In a query response, an asterisk (*) after the version number indicates the version that is currently used.
• A question mark (? or ?.??) indicates that the factory default firmware is the only firmware loaded in the IPL T S unit.
• A carat (^) indicates the version of firmware that should be running, but, since a mode 1 reset was performed, the factory default firmware version is loaded and running instead.
• An exclamation point (!) indicates that the firmware is corrupted.
•
Responses to commands differ depending on which, if any, verbose response mode the IPL T S device is in. See the
or
Query firmware version Q
1Q
Example: 1Q
Query verbose firmware 0Q
version information
Example: 0Q
Query bootstrap 2Q
firmware version
2Q
Example:
Query factory firmware 3Q
version
Example: 3Q
Query updated firmware 4Q
version
Example: 4Q
X1!
= Unit firmware version
KEY:
URL Encoded (Web)
Host to Unit)
or
Q 1Q
1Q
0Q
0Q
2Q
2Q
3Q
3Q
4Q
4Q
n.nn
(to the second decimal place)
Response Additional Description
(Unit to Host)
E X2@
CV
command ( CV
X1! ] Show the IPL T S unit firmware version (
decimal places. This query yields the number of
or X1! ]
Ver01*
the currently running version of the user-updatable
1.01
firmware.
or
Ver01*1.01
Sum of responses from Show the bootstrap, factory-installed, and updated
firmware versions.
]
2Q-3Q-4Q
See 2Q, 3Q, and 4Q below.
or
Ver00*sum of responss
]
from 2Q-3Q-4Q
1.03-1.00(1.18-IPL Series -Thu, 20 Jan 2005 09:41:47 GMT)-
1.01*(1.31-IPL Series -Tue, 14 Jun 2005 00:54:58 GMT)
The bootstrap firmware is not user-replaceable,
X1! ]
but you may need this information during
or X1!]
Ver02*
troubleshooting.
]
1.03
Factory-installed firmware is different from the
X1!
(plus web ver.-desc-UL
bootstrap firmware, but it is also not user-replaceable.
]
date/time)
This firmware was installed at the factory; it is the
version the controller reverts to after a mode 1 reset
or X1!
Ver03* (plus web
(see ch. 2).
]
ver.-desc-UL date/time)
1.00(1.18-IPL Series -Thu, 20 Jan 2005 09:41:47 GMT)
In this example the factory firmware version
is 1.00 and the IP Link kernel version is 1.18 for the
IPL T S unit, dated 20 January 2005.
X1! Use this command to find out which version of the
(plus web ver.-desc-UL
firmware, if any, was uploaded into the controller
]
date/time)
after it left the factory.
or X1!
Ver04* (plus web
]
ver.-desc-UL date/time)
1.01*(1.31-IPL Series -Mon, 28 Feb 2005 23:16:55 GMT)
In this example the current firmware version is 1.01,
the IP Link kernel version is 1.31, for the IPL T S
device, dated 28 February, 2005.
IPL T S Series • Communication and Control
}
) under IP setup commands later in this table.
X1!
]
]
]
) to two
33