Table of Contents
Advertisement
TX LEDs — (see
3
indicates data is being transmitted from the corresponding serial port.
RX LEDs — A green LED indicates data is being received by the corresponding serial
4
port.
RTS LEDs — A green LED indicates that the corresponding serial port is ready to send
5
data.
CTS LEDs — A green LED indicates that the device controlled by the corresponding
6
serial port is ready to accept data.
ACT (Activity) LED — A yellow LED indicates that data is being sent/received.
7
LINK LED — A green LED indicates that the unit is connected to an active network.
8
100 LED — A green LED indicates that the connection speed is 100 Mbps. If the LED
9
is not lit, the connection speed is 10 Mbps.
Resetting the Unit
There are five reset modes available by pressing the Reset button (
The Reset button is recessed, so use a pointed stylus, ballpoint pen, or Extron Tweeker to
access it. See the following table for a summary of the modes.
ATTENTION:
•
Review the reset modes carefully. Using the wrong reset mode may result in
unintended loss of flash memory programming, port reassignment, or a controller
reboot.
•
Analysez minutieusement les différents modes de réinitialisation. Appliquer
le mauvais mode de réinitialisation peut causer une perte inattendue de la
programmation de la mémoire flash, une reconfiguration des ports ou une
réinitialisation du processeur.
The reset modes listed below (with the exception of Mode 2) close all open IP and
•
Telnet connections and close all sockets.
•
Les modes de réinitialisation répertoriés ci-dessous (à l'exception du Mode 2)
ferment toutes les connexions IP et Telnet ouvertes ainsi que les prises de courant.
•
If the
(blinks) and puts the unit in a different mode. The Mode 5 LED blinks three times,
the third blink indicating that it is the last mode. The following modes are separate
functions, not a continuation from Mode 1 to Mode 5.
figures 12, 13, 14, and 15
button is continuosly held down, every three seconds the LED pulses
Reset
on the previous page) A green LED
) on the side panel.
2
IPL T S Series • Installation and Operation
12
Advertisement
Table of Contents
