Table of Contents
Advertisement
5.
Reliable earthing (grounding) — Reliable earthing of rack-mounted equipment
should be maintained. Particular attention should be given to supply connections other
than direct connections to the branch circuit (such as the use of power strips).
Mounting Options
All units are easily mounted in a rack, under a desk or podium, or on a projector mount.
Mounting kits and IPL T S Series device compatibility are shown in the table below.
Mounting Type
MBU 125 Under-desk mount
MBU 123 Under-furniture mount
PMK 200 Projector mount
PMK 100 Projector mount
RSU 129 1U 9.5-inch Deep universal rack shelf
RSF 123 1U 3.5-inch Deep rack shelf
Rack Mounting an IPL T S Series Interface
For available rack mount kits available, go to www.extron.com.
To rack mount an IPL T S Series unit (see figure 2 and
1.
Remove the rubber feet from the bottom of the IPL T S unit if applicable.
2.
Secure the underside of the unit on the rack shelf with two 4-40 x 3/16-inch screws in
opposite (diagonal) corners.
3.
Install additional units or blank panels on the rack shelf as desired.
4.
Insert the shelf into the rack at the desired location.
5.
Secure the shelf to the rack using the supplied mounting screws.
1U Rack Shelf
1/4 Rack Width False Front
Use 2 mounting holes on
opposite corners.
Figure 2.
NOTE: Only products that are 3.5 inches deep can be mounted to a 1U 3.5-inch Deep
Rack Shelf. Any 1U or 1-inch high rack-mountable Extron product can be mounted on
the Universal 1U Rack Shelf (see figure 3).
IP L
T S
2
R
CO
M
1
2
®
10
0
IP L
LI NK
T S
2
AC
T
R
CO
M
1
2
®
10
0
LI NK
AC
T
Face Plate
IP L
T S
2
R
CO
M
1
2
®
10
0
LI NK
AC
T
(2) 4-40 x 3/16" Screws
Rack Mounting the Interface on the Rack Shelf
S1
S2
S4
•
•
•
•
•
•
•
•
figure 3
on page 6):
IPL T S Series • Installation and Operation
S6
•
•
•
•
•
•
•
•
5
Advertisement
Table of Contents
