Extron electronics IPL T S Series User Manual page 39

Command ASCII (Telnet)
(Host to Unit)
Bidirectional Serial Data Port (continued)
Configure pass-thru
E X! X5)
*
mode
24
Terminate pass-thru
E X!
*0CD
mode
24
View pass-thru mode
24
E X! }
CD
Ethernet data port
Set current connection E X6(
0* TC
port timeout
View current connection E }
0TC
port timeout
Set global IP port
E X6(
1* TC
timeout
View global IP port E }
1TC
timeout
X!
01
KEY: = Specific port number (
X2!
= Parameter to set either Length of message to receive or Delimiter value. If length delimited, use xxL, where xx is the length of the incoming message in bytes. If character delimited, use
xxD, where xx is the decimal ASCII value of the delimiting character.
X5)
= Redirect: 0 = no redirect; 1–n = redirect serial port from the specified port to allow for a transparent pass-through mode
X5#
= Timeout for data pass-through mode, after which event data can be inserted into the transmit buffer.
X6(
= IP connection timeout period in seconds. Each step is specified in 10-second intervals (1 - 65000, default = 30 = 300 seconds).
If no data is received during the specified period, the Ethernet connection closes. Responses are returned with leading zeros.
URL Encoded (Web)
Host to Unit)
X5# X2! } X! X5) X5#
* * CD W %2A %2A
CD |
X! |
} W %2A0CD
X! |
W CD
} X6( |
W0%2A TC
|
W0TC
} X6( |
W1%2A TC
|
W1TC
99
– ) 1 = rear host (Host Control RS-232 port)
2 = front panel Config port
3 = slaved switcher (MLS port)
Response
(Unit to Host)
X2! X! X5) X5# X2!]
%2A Cpn •Ccd , ,
X!
Cpn •Ccd
]
00000,00000,00000L
X5) X5# X2!]
, ,
X6(]
Pti0*
X6(]
X6(]
Pti1*
X6(]
4 = display port (Projector RS-232/IR)
5 = IR/Serial port A
6 = IR/Serial port B
IPL T S Series • Communication and Control
Additional Description
The current port timeout period applies to the
currently open Telnet session only. When you start
another Telnet session, it uses the default global port
timeout period.
X6(
= This variable is applicable only when the
IPL T S unit is connected via Ethernet. If the IPL
T S device is connected via RS-232 protocol,
only the global timeout commands apply, and any
X6(
commands involving return the E13 error
response.
The global port timeout is the default timeout period
for all Telnet sessions.
This timeout period is applicable only when the IPL
T S unit is connected via Ethernet, and you must be
logged in as an administrator to change this setting.
7 = IR/Serial port C
32