Setting The Ip Address Using The Arp Command - Extron electronics IPL T S Series User Manual

To return the local PC to its original TCP/IP settings:
1. Close the web browser.
2. Disconnect the Ethernet crossover cable from the PC and the device.
3.
Return to the TCP/IP Properties dialog box on the PC.
4. Return the IP address, Subnet mask, Default gateway, and DHCP fields to their original
settings.
5. Reboot the PC.

Setting the IP Address Using the ARP Command

An IPL T S unit IP address can be set using the DOS Address Resolution Protocol (ARP)
command.
The IPL T S unit must be:
Physically connected to the network
•
• At the factory default IP address
To set an IP address using the ARP command:
1. Open a command prompt window on a local PC. On Windows XP, a command prompt
window can be found at:
Start > All Programs > Accessories > Command Prompt
2. At the command prompt type:
arp - s<IP address><MAC address>
example: C:\>arp -s 10.13.197.64 00-05-A6-00-30-5F
The example command assigns IP address 10.13.197.64 to the device that has a MAC
address of 00-05-A6-00-30-5F.
Figure 22.
3. To confirm the new IP address is active, perform a ping command to the new IP
address.
example: C:\>ping 10.13.197.64
If the IP address setting was successful, the device replies 3 or more times:
Reply from <IP address>: bytes=32 time <1ms TTL=64
Executing the ARP Command
IPL T S Series • Introduction 19