Table of Contents
Advertisement
IPL T S4
R
1
2
Figure 18.
Power LED — A green LED lights to indicate that the interface is receiving power.
1
Blinks four times to confirm a Mode 4 reset.
Reset button — The
2
to activate.
Setting the IP Address Using Global Configurator
The preferred method for setting a unit IP address is to use the Extron Global Configurator
(GC) application.
If you have Global Configurator installed on a local PC, and have a GC project file open,
proceed with the steps below. If you do not have Global Configurator installed, it is
available as a free download from www.extron.com. The GC help file leads you through
the process of creating a new GC project file, and provides an illustrated version of the
procedure below.
The IPL T S unit must be:
•
physically connected to the network
at its factory default IP address
•
To set an IP address with a GC project file open:
1.
From the
The Add Device dialog box opens (see
2.
Select the appropriate device type (for example, IPL T S4) in the IP Link Device
drop-down list.
3.
Enter the new IP address (for example, 10.14.195.40) in the Name/IP Address field.
Enter a unique device name in the Display Name field.
4.
5.
Click the Advanced >>> button.
The Advanced options of the Add Device dialog are displayed, and the Advanced >>>
button name changes to Basic <<<.
6.
Enable the Auto Configure IP Address check box.
7.
Enter the MAC address for the unit in the MAC Address field.
The first six digits (00-05-0A) are pre-populated, and identify this unit as an Extron
device.
You only need to enter the final six digits. Dashes between digits are auto-filled.
8.
Click the Set button.
The Auto Configure Successful dialog box opens.
9.
Click OK.
COM
100
1
3
LINK
ACT
2
4
IPL T S Front Panel
button is recessed. Use an Extron Tweeker or similar tool
Reset
menu, select Add Device.
Edit
figure 19
on page 17).
IPL T S Series • Introduction
16
Advertisement
Table of Contents
