Table of Contents
Advertisement
IP L
T S
2
R
C O
M
1
2
Figure 3.
Furniture or Projector Mounting
To mount an IPL T S Series device to furniture:
1.
If present, remove the rubber feet from the bottom of the IPL T S unit.
2.
Attach the furniture mounting brackets to the unit with the supplied screws.
3.
Hold the unit with the attached brackets against the underside of the furniture. Mark the
hole locations of the bracket on the mounting surface.
4.
Drill 3/32-inch (2 mm) diameter pilot holes, 1/4 inches (6.3 mm) deep in the underside of
the mounting surface at the marked hole locations.
5.
Insert #8 wood screws into the four pilot holes. Tighten each screw until just less than
1/4 inches (6.3 mm) of the screw head protrudes above the surface.
6.
Hang the mounting bracket over the protruding screw heads. Slide the mounting
brackets to the narrow end of the screw slots and tighten the mounting screws.
To mount an IPL T S Series device with a projector (see figure 4):
1.
If present, remove the rubber feet from the bottom of the IPL T S unit.
2.
Attach the projector mounting bracket to the unit with the supplied screws.
3.
Secure the unit to the projector post with the supplied mounting bolt.
Furniture Mount
IP L
T S
2
R
C O
M
1
2
10
0
L IN
K
A C
T
Figure 4.
®
1 0
0
IP L
L IN
T S
K
2
A C
T
R
C O
M
1
2
®
1 0
0
L IN
K
A C
T
Mounting the Interface on the Standard Shelf
Projector
Mounting
Bracket
Digital Projector
Mounting the Interface
Mounting
Bolt
Projector Mount
IPL T S Series • Installation and Operation
6
Advertisement
Table of Contents
