Advertisement
Tip: To make the QSIG or
set emulation telephony
interface active, click the
down arrow and click
Make
Active.
If the QSIG or set
emulation telephony
interface is already active,
this field does not appear.
AVAYA E1/QSIG
Next access the General tab within the Telephony Interface
(Dialogic-QSIG) tab
1. Playback Volume = 2
2. Maximum Concurrent Calls = Enter the number of ports
connected to the PBX (i.e. 29)
3. Port = Ports are enabled by default
Note: The MAS service must be restarted to allow port disabling
4. Select OK to save changes
Note: For a QSIG link, the total number of ports specified must occupy the
first available set of contiguous channels. For example, if there are two
boards on a system, one with 10 ports enabled and one with 29 ports
enabled, then the first 10 ports will be enabled on one boards, and all 29
on the second board. Use the port checkboxes to enable or disable the
correct ports.
The above information is provided by AVAYA Inc. as a guide. See disclaimer on page 1
22
Advertisement
