Advertisement
NCA-TSCs are used for QSIG.
CA-TSCs are used with DCS+
-----------------
Trunk Group for NCA TSC
should have a value to indicate
trunk group only if using MWI
Interrogation.
AVAYA E1/QSIG
Install the E1 circuit pack, making sure they are "strapped" for 30-channel
operation (E-1). Configure the DS1 circuits as follows:
display ds1 01b17
Location: 01B17
Bit Rate: 2.048
Signaling Mode: isdn-pri
Connect: pbx
CentreVu Long Timers? n
Interworking Message: PROGress
Interface Companding: alaw
Idle Code: 11111111
Slip Detection? n
Configure a Signaling Group that will be assigned to the DS1 channels. The
Signaling Group should be configured as follows:
display signaling-group 1
Group Number: 9
Associated Signaling? y
Primary D-Channel: 01b1716
Trunk Group for Channel Selection: 1
Supplementary Service Protocol: b
Important: The Max number of NCA TSC (Non-Carrier Associated Temporary
Signaling Channels) should be 1 or higher. This allows a path (1 or more) for
MWI to operate.
The above information is provided by AVAYA Inc. as a guide. See disclaimer on page 1
DS1 CIRCUIT PACK
Line Coding: hdb3
Peer Protocol: Q-SIG
Channel Numbering: timeslot
DCP/Analog Bearer Capability: 3.1kHz
Near-end CSU Type: other
SIGNALING GROUP
Group Type: isdn-pri
Max number of NCA TSC: 10
Trunk Group for NCA TSC: 1
X-Mobility/Wireless Type: NONE
7
Name: E1 QSIG
Interface: peer-master
Side: a
CRC? n
Page
1 of
5
Max number of CA TSC: 10
Advertisement
