Advertisement
NOTICE:
The screens in this
Config Note are only
for illustration
purposes.
It is recommended that
a qualified technician
review the customer's
CM QSig programming
for accuracy.
AVAYA E1/QSIG
9.0. ADDENDUM ON CONFIGURING MULTIPLE PBXS
(DCS+ NETWORKING/INTERNETWORKING)
The following information is not intended for new installations. This Addendum
assumes the customer has an existing Network already in place. Please refer to
the appropriate PBX installation guide for brand new networking installations.
Obtain a configuration printout of the existing network to use as a reference.
Ensure the integration is working properly within the PBX where the MAS will
reside (Hub Node) before continuing with the networking configuration.
Configure the remote switch (i.e. Node 2), Definity G3, Prologix, etc., by
following the screens below.
The Hub Node will not require changes to the Trunk Group; however configure
the Signaling Group, which will be assigned to the DS1 channels. The following is
an example of the changes highlighted in boldface:
change signaling-group 7
Group Number: 7
Associated Signaling? y
Primary D-Channel: 01A0824
Trunk Group for Channel Selection: 4
Supplementary Service Protocol: a
change signaling-group 7
Service/Feature:
TSC
Local
Index
Ext.
Enabled Established
1:
2299
y
2:
3081
y
3:
n
4:
n
5:
n
etc..
Note: The Group Type will depend on the customer's environment. The trunks
can either be T1, E1, IP, etc.. For example, they could be:
Group Type: isdn-pri or Group Type: h.323
Additionally, you should consult with a Software Specialist to ensure the
Numbering Format of the trunk group is configured appropriately to route Call ID
to the Modular Messaging from remote switches.
The above information is provided by AVAYA Inc. as a guide. See disclaimer on page 1
SIGNALING GROUP
Group Type: isdn-pri
Trunk Group for NCA TSC: 4
ADMINISTERED NCA TSC ASSIGNMENT
As-needed Inactivity Time-out (min):
Dest. Digits
permanent
2100
permanent
3083
34
Page
1 of
5
Max number of NCA TSC: 16
Max number of CA TSC: 31
Page
2 of
5
Mach.
Appl.
ID
dcs
1
qsig-mwi
2
Advertisement
