G Group 2: Non-Modally Valid Motion, Dwell Time; G Group 3: Programmable Frame, Working Area Limitation And Pole Programming - Siemens SINUMERIK 840D sl Programming Manual

Tables
4.3 G commands
4.3.3

G group 2: Non-modally valid motion, dwell time

G command No.
1)
G4 1
G63 2
G74 3
G75 4
REPOSL 5
REPOSQ 6
REPOSH 7
REPOSA 8
REPOSQA 9
REPOSHA 10
G147 11
G247 12
G347 13
G148 14
G248 15
G348 16
G5 17
G7 18
4.3.4

G group 3: Programmable frame, working area limitation and pole programming

G command No.
1)
TRANS 1
ROT 2
SCALE 3
MIRROR 4
ATRANS 5
AROT 6
ASCALE 7
AMIRROR 8
- 9
G25 10
1248
Meaning
Dwell time, preset
Tapping without synchronization
Reference point approach with synchronization
Fixed-point approach
Linear repositioning
Repositioning in a quadrant
Repositioning in semicircle
Linear repositioning with all axes
Linear repositioning with all axes, geometry axes in
quadrant
Repositioning with all axes; geometry axes in semicir‐
cle
Approach contour with straight line
Approach contour with quadrant
Approach contour with semicircle
Leave contour with straight line
Leave contour with quadrant
Leave contour with semicircle
Oblique plunge-cut grinding
Compensatory motion during oblique plunge-cut grind‐
ing
Meaning
TRANSLATION: Programmable offset
ROTATION: Programmable rotation
SCALE: Programmable scaling
MIRROR: Programmable mirroring
Additive TRANSLATION: Additive programmable
translation
Additive ROTATION: Programmable rotation
Additive SCALE: Programmable scaling
Additive MIRROR: Programmable mirroring
Unassigned
Minimum working area limitation/spindle speed limita‐
tion
MD20150 W
2)
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
- s
MD20150 W
2)
- s
- s
- s
- s
- s
- s
- s
- s
-
- s
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
STD
3) 4)
SAG MH
STD
3) 4)
SAG MH
-
NC programming