G Group 27: Tool Offset For Change In Orientation At Outside Corners; G Group 28: Working Area Limitation; G Group 29: Radius/Diameter Programming; G Group 30: Nc Block Compression - Siemens SINUMERIK 840D sl Programming Manual

Tables
4.3 G commands
4.3.27

G group 27: Tool offset for change in orientation at outside corners

G command No.
1)
ORIC 1
ORID 2.
4.3.28

G group 28: Working area limitation

G command No.
1)
WALIMON 1
WALIMOF 2
4.3.29

G group 29: Radius/diameter programming

G command No.
1)
DIAMOF 1
DIAMON 2
DIAM90 3
DIAMCYCOF 4
4.3.30

G group 30: NC block compression

G command No.
1)
COMPOF 1
COMPON 2
1256
Meaning
Orientation changes at outside corners are superim‐
posed on the circle block to be inserted
Orientation changes are performed before the circle
block
Meaning
Working area limitation ON
Working area limitation OFF
Meaning
Modal channel-specific diameter programming OFF
Deactivation activates channel-specific radius pro‐
gramming.
Modal independent channel-specific diameter pro‐
gramming ON
The effect is independent of the programmed dimen‐
sions mode (G90/G91).
Modal dependent channel-specific diameter program‐
ming ON
The effect is dependent on the programmed dimen‐
sions mode (G90/G91).
Modal channel-specific diameter programming during
cycle processing OFF
Meaning
NC block compression OFF
Compressor function COMPON ON
MD20150 W
2)
+ m
+ m
MD20150 W
2)
+ m
+ m
MD20150 W
2)
+ m
+ m
+ m
+ m
MD20150 W
2)
+/- m
+/- m
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
STD
3) 4)
SAG MH
x
STD
3) 4)
SAG MH
x
STD
3) 4)
SAG MH
x
STD
3) 4)
SAG MH
x
NC programming