Cycle150 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Work preparation
3.25 Programming cycles externally
No. Screen Cycle pa‐
form pa‐ rameter
rameter
22
_AMODE
All default values = 0 or marked as default=x
1)
Display depends on the general SD54762 MEA_FUNCTION_MASK_TOOL
2)
Only for offset in tool and dimensional tolerance "Yes", otherwise parameter = 0
3)
For automatic measurement (S_MVAR=1x00xx), no display of measuring axis, offset axis ⇒ S_MA=0.
4)
3.25.3.16

CYCLE150 measuring cycle parameters

PROC CYCLE150(INT S_PICT,INT S_PROT,STRING[160] S_PATH) SAVE
ACTBLOCNO DISPLOF
Table 3-23 CYCLE150 call parameters
No. Screen pa‐ Cycle pa‐
rameters rameters
1 Measuring
S_PICT
result
screen
2
S_PROT
1194
Meaning
Alternative mode
Val‐ UNITS: Measuring the tool offset for radius
ues:
1 = No
2 = Yes
TENS: Direction of the tool offset when measuring the radius in the 3rd axis of the
plane (for G17 Z)
1 = Positive
2 = Negative
HUNDREDS: Tool offset when measuring the length or when calibrating the probe
in the 3rd axis
0 = Compatibility, auto
1 = No
2 = Yes
THOUSANDS: Direction of the tool offset when measuring the length in the offset
axis (see S_MA HUNDREDS)
1 = Positive
2 = Negative
Meaning
Select result display (default = 0)
Values: UNITS:
0 = Measuring result screen OFF
1 = Measuring result screen ON
Tens: Select display mode (values as for SD55613)
1 = Display measuring result screen - automatically deselect after 8 s
3 = Display measuring result screen - acknowledge using NC Start
4 = Display measuring result screen - only for alarms (61303 ... 61306)
Select logging (default = 0)
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
NC programming