Cycle982 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

3.25.3.14

CYCLE982 measuring cycle parameters

PROC CYCLE982(INT S_MVAR,INT S_KNUM,INT S_PRNUM,INT S_MA,INT S_MD,REAL S_ID,REAL S_FA,REAL
S_TSA,REAL S_VMS,REAL S_STA1,REAL S_CORA,REAL S_TZL,REAL S_TDIF,INT S_NMSP,INT S_EVNUM,INT
S_MCBIT,INT _DMODE,INT _AMODE)
Table 3-21 CYCLE982 call parameters
No. Screen Cycle pa‐
form param‐ rameter
eter
1
S_MVAR
2 Selection
S_KNUM
3 Icon+
S_PRNUM
number
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
1)
Meaning
Measuring variant
Val‐ UNITS: Calibration/measurement
ues:
0 = Calibrate tool probe
1 = Single tool measurement
2 = Multiple tool measurement, determine lengths and tool radius (for milling tools)
TENS: Calibration or measurement in the MCS or WCS
0 = Machine-related
1 = Workpiece-related
HUNDREDS: Measurement with or without reversal for milling tools
0 = Measurement without reversal
1 = Measurement with reversal
THOUSANDS: Correction target for milling tools
0 = Determine length or length and radius (see S_MVAR 1st position)
1 = Determine radius if S_MVAR 1st position = 1
2 = Determine length and radius (face side) if S_MVAR 1st position = 1 or 2
3 = Determine side milling cutter upper cutting edge (rear side) and length and
radius
5)
TEN THOUSANDS: Position of the milling tool or the drill
0 = Axial position of the milling tool or drill, radius in 2nd axis of the plane (for G18
X)
7)
1 = Radial position of the milling tool or the drill, radius in 1st axis of the plane (for
G18 Z)
7)
HUNDRED THOUSANDS: Incremental calibration or measurement
0 = No specification
1 = Incremental calibration or measurement
ONE MILLION: Position spindle at starting angle S_STA1 (only for measurement of
milling tools)
0 = Spindle is not positioned
1 = Spindle is positioned at the starting angle S_STA1
Offset variant
2)
Val‐ UNITS: Tool offset
ues:
0 = No specification (tool offset in geometry)
1 = Tool offset in wear
Number of the field of the probe parameters (not probe number)
(default=1)
3.25 Programming cycles externally
3)
4)
Work preparation
1189