Siemens SINUMERIK 840D sl Programming Manual page 1179

No Screen Cycle pa‐
. form param‐ rameter
eter
3 Selection
S_KNUM1
4 Icon+
S_PRNUM
number
5 X0
S_SETV
6 DFA
S_FA
7 TSA
S_TSA
8 X0
S_CPA
9 Y0
S_CPO
10 XM
S_XM
11 YM
S_YM
12 alpha 0
S_STA1
13 alpha 1
S_INCA
14 Measure‐
S_NMSP
ments
15 ST
_DP
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Meaning
Correction in tool offset
2)
Val‐ UNITS:
ues:
TENS:
HUNDREDS:
0 = No correction
1 to max. 999 D numbers (cutting edge numbers) for tool offset; for additive and
setup offset, see also S_DLNUM
THOUSANDS: 0 or unique D numbers
TEN THOUSANDS: 0 or unique D numbers
1 to max. 32000 if unique D numbers in MDs have been set up
HUNDRED THOUSANDS: Tool offset
0 = No specification (offset in tool radius)
1 = Offset of length L1
2 = Offset of length L2
3 = Offset of length L3
4 = Radius offset
ONE MILLION: Tool offset
0 = No specification (offset of the tool radius wear)
1 = Tool offset, additive offset (AO)
Tool offset value is added to the existing AO
2 = Tool offset, setup offset (SO)
SO (new) = SO (old) + AO (old) offset value, AO (new) = 0
3 = Tool offset, setup offset (SO)
Tool offset value is added to the existing SO
4 = Tool offset, geometry
TEN MILLION: Tool offset
0 = No specification (offset in tool geometry normal, not inverted)
1 = Offset inverted
HUNDRED MILLIONS: Tool offset
0 = Tool offset without replacement tools
1 = Tool offset in replacement tool (_DP)
Number of the field of the probe parameters (not probe number)
(value range 1 to 40)
Setpoint
Measurement path
Safe area
Center point of the 1st axis of the plane (for G17 X)
Center point of the 2nd axis of the plane (for G17 Y)
Setpoint center point input geometry axis X
Setpoint center point input geometry axis Y
Starting angle
7)
Incremental angle
8)
Number of measurements at the same location
Number of the replacement tool (duplo number) to be corrected
3.25 Programming cycles externally
2)
2)
5)
5)
5)
2)
(value range 1 to 9)
1)
Work preparation
1179