Cycle971 Measuring Cycle Parameters - Siemens SINUMERIK 840D sl Programming Manual

Display depends on the general SD54762 _MEA_FUNCTION_MASK_TOOL
2)
Measure turning or milling tool or drill. Measuring axis in parameter S_MA
3)
Specification for turning tools via cutting edge position 1...8, for milling tools via HUNDREDS to THOUSANDS position in
parameter S_MVAR.
Measurement and calibration are performed in the basic coordinate system (MCS for kinematic transformation switched off).
4)
Not for incremental measuring
5)
Only for multiple measurements S_MVAR=x2x02 or x3x02 (example, disk-type or groove milling tools)
6)
If the channel-specific SD42950 $SC_TOOL_LENGTH_TYPE = 2, then the tool length components are assigned just the
7)
same as for turning tools
Only for measurement with reversal S_MVAR=xx1x1
8)
Empirical value generation
9)
Value range of the empirical value memory: 1 to 20 numbers (n) of the empirical value memory, see channel-specific
SD55623 $SCS_MEA_EMPIRIC_VALUE[n-1].
3.25.3.15

CYCLE971 measuring cycle parameters

PROC CYCLE971(INT S_MVAR,INT S_KNUM,INT S_PRNUM,INT S_MA,INT S_MD,REAL S_ID,REAL S_FA,REAL
S_TSA,REAL S_VMS,REAL S_TZL,REAL S_TDIF,INT S_NMSP,REAL S_F1,REAL S_S1,REAL S_F2,REAL
S_S2,REAL S_F3,REAL S_S3,INT S_EVNUM,INT S_MCBIT,INT _DMODE,INT _AMODE)
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Work preparation
3.25 Programming cycles externally
1191