Siemens SINUMERIK 840D sl Programming Manual page 1229

Operation Type
for explanations, see legend (Page 1197).
1) 2) 3) 4) 5)
TANGON P
TCA P
(828D: _TCA)
TCARR A
TCI P
TCOABS G
6)
TCOFR G
TCOFRX G
TCOFRY G
TCOFRZ G
THETA A
TILT A
TLIFT P
TML P
TMOF P
TMON P
TO K
TOFF A
TOFFL A
TOFFLR A
TOFFOF P
TOFFON P
TOFFR A
TOFRAME G
TOFRAMEX G
TOFRAMEY G
TOFRAMEZ G
TOLOWER
TOOLENV
NC programming
Programming Manual, 12/2019, 6FC5398-2EP40-0BA0
Meaning
1)
Tangential control: Activate coupling
Tool selection/tool change irrespective of tool
status
Request toolholder (number "m")
Load tool from buffer into magazine
Determine tool length components from the
current tool orientation
Determine tool length components from the
orientation of the active frame
Determine tool orientation of an active frame
on selection of tool, tool points in X direction
Determine tool orientation of an active frame
on selection of tool, tool points in Y direction
Determine tool orientation of an active frame
on selection of tool, tool points in Z direction
Angle of rotation
Tilt angle
Tangential control: Activate intermediate
block generation
Tool selection with magazine location number
Deselect tool monitoring
Activate tool monitoring
Designates the end value in a FOR counter
loop
Tool length offset in the direction of the tool
length component that is effective parallel to
the geometry axis specified in the index.
Tool length offset in the direction of the tool
length component L1, L2 or L3
Simultaneous tool length offset and tool radius
offset
Deactivate online tool offset
Activate online tool length offset
Tool radius offset
Align Z axis of the WCS by rotating the frame
parallel to the tool orientation
Align X axis of the WCS by rotating the frame
parallel to the tool orientation
Align Y axis of the WCS by rotating the frame
parallel to the tool orientation
As TOFRAME
F Convert the letters of a string into lowercase
F Save current states which are of significance
to the evaluation of the tool data stored in the
memory
W TP SA Description see
2) 3) 4)
+/- - PM-NC
+/- - FM-TM
+/- PM-NC
+/- - FM-TM
m +/- PM-NC
m +/- PM-NC
m +/- PM-NC
m +/- PM-NC
m +/- PM-NC
s +/- PM-NC
m +/- PM-NC
+/- - PM-NC
+/- - FM-TM
+/- - PM-NC
+/- - PM-NC
+/- PM-NC
m +/- PM-NC
m +/- PM-NC
m +/- PM-NC
+/- - PM-NC
+/- - PM-NC
m +/- PM-NC
m +/- PM-NC
m +/- PM-NC
m +/- PM-NC
m +/- PM-NC
+/- - PM-NC
+/- - PM-NC
Tables
4.1 Operations
5)
1229