Table of Contents
Advertisement
Installation
I
Some of the devices that you connect require special drivers (see the
documentation for the connected device).
If a separate graphics card is used in a slot, then the graphics controller on the
system board is automatically deactivated. The related monitor port (7) cannot
be used. Instead, connect the data cable of the monitor to the monitor port of
the graphics card.
Ê Connect the data cables at the server and peripherals.
3.5.1
Routing the cables
19-inch rack (23 HU and 42 HU)
If the server is installed in a 19-inch rack (without cord management), an artic-
ulated cable guide must be mounted on the device:
Ê Insert two spring nuts in the groove of the right rear support upright at the
same height at which the articulated cable guide is attached to the server.
Figure 9: Mounting the articulated cable guide
U41147-J-Z156-2-76
Connecting devices to the rack model
31
Advertisement
Table of Contents
