Table of Contents
Advertisement
Appendix
Upgrading second SCSI backplane (1-inch HD subsystems)
Figure 51: Mounting the divider plate
Ê Insert the delivered divider plate for the two hard disk units as shown above
(1). Make sure care that the rear side of the divider plate is positioned in the
groove at the rear side of the cage, and mount it with the two fastening
screws (2).
Ê Put the cage for the hard disk drives on the working surface with the SCSI
backplane facing upwards (see figure 52 on page 106).
V
CAUTION!
Make sure that the cables are not under tension. When you are
working under cramped conditions, first mark the cables connected
to the SCSI backplane, then pull them out, and continue working.
U41147-J-Z156-2-76
105
Advertisement
Table of Contents
