Table of Contents
Advertisement
System components and expansions
Installing 1-inch hard disk drives
Figure 23: Installing the 1-inch hard disk drives
Ê Push the internal hard disk drive module into the bay (1) as far as possible,
and then swing the handle of the hard disk drive module completely down to
allow the locking mechanism to engage (2). Pay attention to the locking
button for the module handle (marked with (4) in figure 19 on page 67): it
must slide in the corresponding hole.
Removing is done in the reverse order.
V
CAUTION!
Never pull out a hard disk drive during operation if you are not sure that
the hard disk drive operates on a RAID controller and is part of a disk
array that operates in RAID level 1 or 5.
U41147-J-Z156-2-76
SCSI hard disk subsystem
71
Advertisement
Table of Contents
