Table of Contents
Advertisement
Converting a floorstand model into a rack model
Figure 64: Mounting the front panel
Ê Screw the front panel of the rack model loosely to the assembly frame in the
middle at the top using two countersunk head screws (1). The front panel
must be able to project downward over the edge of the table.
Ê Now fasten the front panel firmly to the system unit with the other twelve
countersunk head screws (2).
Ê Mount the server into the rack (see section "Installing the rack model" on
page 26).
Ê Attach the cables to the server according to the required rack configuration
(see section "Connecting devices to the rack model" on page 29).
Ê Route the cables as described in section "Routing the cables" on page 31.
Ê Connect the server to the line voltage (see section "Connecting the server
to the line voltage" on page 35).
Ê Change the chassis ID as described in the following section "Changing the
chassis ID". Modify the settings for the chassis ID to "H200R" and for the
chassis type to "17H".
118
Appendix
U41147-J-Z156-2-76
Advertisement
Table of Contents
