Appendix
Figure 73: Mounting the chipcard reader
Ê Push the carrier with the chipcard reader into the cage (1).
Ê Screw the carrier to the cage (2).
Figure 74: System board: connector for the chipcard reader
Ê Connect one end of the delivered data cable to the corresponding connector
(secondary serial port) provided on the system board (1). Refer to the
technical manual of the system board for assistance.
Ê Carefully route the cable through the opening in the separator wall of the
server up to the mounting location of the cage.
Ê Carefully push the cage with the installed chipcard reader into the server.
U41147-J-Z156-2-76
Mounting/removing the chipcard reader
127