Chapter 2: Configuring The Hardware In The Rack - Avaya S8700 Series Installing And Configuring

Chapter 2: Configuring the hardware in the rack

Once the control network equipment is installed and connected, you must configure the SNMP
Modules in each UPS (if Avaya supplied), the SNMP Subagent in the Avaya Ethernet switch (if
Avaya supplied), and the two media servers. The first two are to allow that equipment to send
alarms (traps) to the media servers.
Configure the SNMP agents first, then install Avaya Communication Manager on and configure
the first media server and verify its operation before you install Avaya Communication Manager
on and configure the second media server.
This section covers the following procedures:
Configuring the SNMP modules in the UPS on page 30
●
Configuring the SNMP subagent in the Avaya Ethernet switch (if used) on page 34
●
Installing Communication Manager software
●
Configuring the media server
●
Configuring second media server
●
on page 37
on page 42
on page 50
Issue 4.1 June 2005 29