Mitel Aastra 470 System Manual page 223

Behaviour after inserting a valid microSD card
After starting the cordless phone you will receive, in the start phase, a message in-
forming you that a new card with a new ID has been detected.
Accept the card.
 The cordless phone restarts.
 The card's registration data and local settings are used.
 The original data remains stored in the cordless phone and is reactivated once
the card is removed.
Copying local settings using a commercially available microSD card
This procedure is helpful if several cordless phones with the same local settings
must be preconfigured.
1. Carry out on a master cordless phone without microSD card the local settings
you want.
2. Switch off the master cordless phone, insert a commercially available microSD
card then restart the master cordless phone.
3. Confirm the information that the microSD card is invalid.
4. Select Menu - Settings
then copy all user data to the microSD card.
-> The card is now specially marked as a copy card.
5. Switch off the master cordless phone, remove the card and insert the card in the
target cordless phone to which the data must be copied.
6. Start the target cordless phone and confirm the information that the user data
on the card will be used.
7. Copy all user data from the card to the memory of the target cordless phone.
-> The target cordless phone restarts.
8. Switch off the target cordless phone and remove the card.
-> After the target cordless phone is switched on again the copied user data is
used.
Aastra 470 as of R3.2
syd-0337/1.6 – R3.2 – 09.2014
- General - Administration
Operation and Maintenance
- Diagnostics - File Mgmt. Device
223