DC power supply replacement
Installing the DC power supply
Install the DC power supply to the DC input power source of the Ethernet Routing Switch
8300.
Danger:
Risk of injury by electric shock
Before working on this equipment, be aware of proper safety practices and the hazards
involved with electrical circuits. Use only power cords that have a grounding path. Ensure
the switch is properly grounded before powering on the unit.
Procedure steps
1. Switch off the power supply.
2. Remove the filler panel from the power bay if necessary.
3. Grasp the handle of the new power supply.
4. Push the new power supply partway into the bay, leaving the terminal block at the
48
Routine Maintenance
The following figure shows the exact location of the power switches.
Caution:
Save the power filler panel in case you need to operate the Ethernet Routing
Switch 8300 chassis with a power supply removed.
side of the power supply exposed.
May 2011