2. Pull the power filler panel from the chassis.
Job aid: Power filler panel removal
Installing the DC power supply
Install the DC power supply to the DC input power source of the Ethernet Routing Switch
8300.
Caution:
Risk of equipment damage
To prevent damage from electrostatic discharge, always wear an antistatic wrist strap
connected to an ESD jack.
Danger:
Risk of injury by electric shock
Before working on this equipment, be aware of proper safety practices and the hazards
involved with electrical circuits. Use only power cords that have a grounding path. Ensure
the switch is properly grounded before powering on the unit.
Installation — DC Power Supply
See
Job aid: Power filler panel removal
Caution:
Save the power filler panel in case you need to operate the Ethernet Routing
Switch 8300 chassis with a power supply removed.
Installing the DC power supply
on page 29.
May 2011
29