Do not operate the Ethernet Routing Switch 8300 with an empty module slot. If you need to
replace a failed module and you do not yet have a replacement module, leave the failed
module installed or install a filler panel.
Procedure steps
1. Disconnect any cables attached to the ports on the module.
2. Using a Phillips screwdriver, loosen the 2 captive screws that secure the module to
3. Rotate the insert and/or extract levers to eject the module from the chassis.
4. Slide the module out of the chassis.
Routine Maintenance
the chassis.
Removing a module
May 2011
29