Installing A Redundant Power Supply In A 5500 Series Switch - Avaya 5000 Series Installation Manual

Procedures for installation of the switch
Prerequisites
To connect AC power to the switch an appropriate AC power cord is required.
Danger:
Use only power cords that have a grounding path. Without a proper ground, a person who
touches the switch is in danger of receiving an electrical shock. Lack of a grounding path to
the switch may result in excessive emissions.
1. Connect the AC power cord to the back of the switch and then connect the cord
2. Insert the male end of the power cord in a standard 110/220 V AC power outlet.

Installing a redundant power supply in a 5500 Series switch

This procedure describes the steps to install a redundant power supply. This procedures
applies only to 5500 Series switches.
72 Avaya Ethernet Routing Switch 5000 Series Installation
to an AC power outlet. The following figure illustrates connecting the AC power cord
to the switch back panel.
Important:
The 5000 Series switches do not have an AC power switch. When the power cord
is connected to a suitable AC power outlet, the switch powers up immediately.
Warning:
Disconnecting the AC power cord is the only way to turn off AC power to the 5000
Series switches. Always connect the AC power cord in a location that can be
reached quickly and safely in case of an emergency. For a translation of this
statement, see Translations of safety messages
Caution:
Ensure you use an appropriately rated AC power cord only. Do not use an
extension cord.
on page 9.
December 2010