Avaya 8300 Series Routine Maintenance page 57

Caution:
Electrostatic discharge can damage hardware. For more information about antistatic
precautions, see
Procedure steps
1. Locate the slot where you want to install the module.
2. Remove the installed module or the filler panel.
3. Ensure that the insert or the extract levers extend away from the front of the
4. Slide the module into the chassis until the connector panel touches the chassis back
5. Rotate the inserter or the extractor levers to seat the module backplane
6. Use a Phillips screwdriver to tighten the two captive screws that secure the module
Routine Maintenance
Job aid: avoiding electrostatic discharge
module.
panel.
connectors.
in the chassis.
Ensure that both screws are tight for proper module operation. Do not overtighten
the screws.
Installing a module
on page 27.
May 2011 57